![]() If you are recording Stereo Mix, the “driver utilities” (equalization, surround effects, etc.) and similar Windows audio enhancements may alter the sound in a “good” or “bad” way. The soundcard has analog connections, an analog-to-digital converters and a digital-to-analog converter, which you’re not using to record/capture streaming audio. VB-CABLE is a virtual audio device working as virtual audio cable. The drivers & hardware aren’t involved with WASAPI loopback. I’ve been told some of the drivers for the sounds might be substandard or even that this computer’s sound card is garbage. (Unexpected peaks aren’t really a problem for streaming audio since it’s already been digitized.) …In the old days of analog tape you needed a “hot” signal to overcome tape noise, but with digital - no tape noise! With digital, pros often record at -12 to -18dB, leaving plenty of headroom for unexpected peaks. ![]() Except if you over-boost and clip (distort) before or during recording there is no going back.Īnd with WASAPI you are directly capturing the (decompressed) audio stream.Īnd (within reason) digital amplification is audibly perfect. With digital amplification/attenuation, there’s no difference if you adjust before or after recording. Yes…I know I can Amplify it…but it just never comes out sounding as good as when you record something at a good level. Making me crazy!!Īppreciate any suggestions anyone can offer. I’ve also attached a snipe of my Preference Devices under Edit, showing the first page.Īm I missing something? I’ve been trying to get this to work right for the last 5-7 days. Speakers (Realtek (R) Audio) <<<<<<<<this is the only setting available here Here’s how I have it set as I was instructed to do in several Audacity Setup Videos, I viewed after I first downloaded it to this new computer. On this Windows 10, it just seems to be blocking the whole thing off. On my other computer with Windows 7, the volume was always very “hot”Īnd I always had t set it lower. I’ve tried every setting, and I can’t get a good volume. ![]() I try to adjust it…and it gets a little higher, but if I go too high, it starts to distort and feedback with the playback volume. I’ve adjusted the SOUNDS feature several different ways, but when I go to say youtube, and click on a song by some artists…Īnd then go to Audacity and hit the PAUSE and RECORD buttons, so i can set a level…the level comes up, but it’s relatively low. Just bought a new Lenovo Desktop Computer 510A-15ICB.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |